Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Yosh cams along with ported and milled head  (Read 2809 times)

Offline getngone

  • Rider
  • ***
  • Posts: 80
Yosh cams along with ported and milled head
« on: November 02, 2003, 11:39:00 PM »
Calling all supertuners,I've seen some post where guys have made good power by just increasing the compression through the head.Would shaving the head .010 along with yosh stg 1 cams and 30-60hp shot of dry nos on an A&J nos box cause problems?
Logged

Offline project260

  • Post Whore
  • ****
  • Posts: 503
Yosh cams along with ported and milled head
« Reply #1 on: November 02, 2003, 01:52:00 PM »
Would'nt think so, 60 might be a little much  
Logged
the fastest and you know it

Offline gnd111

  • Post Apocalyptic Whore
  • ********
  • Posts: 12410
  • Fried Chicken and Gasoline...
Yosh cams along with ported and milled head
« Reply #2 on: November 02, 2003, 09:15:00 PM »
I am just a rookie and still learning but i don't think you would want to go more than 40 shot on stock pistons....
Logged

Offline Fast Frank

  • Post Whore
  • ****
  • Posts: 529
Yosh cams along with ported and milled head
« Reply #3 on: November 03, 2003, 02:38:00 PM »
I have heard no problems  
Logged
01' Black/Silver,lots of mods
204+ @ Maxton
Pages: [1]   Go Up
« previous next »