Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Yosh RS-3,NEED HELP! Forced me to remove passenger footpegs!  (Read 2779 times)

Offline Cowboy

  • Apprentice Post Whore
  • **
  • Posts: 6
Yosh RS-3,NEED HELP! Forced me to remove passenger footpegs!
« on: August 14, 2004, 04:23:25 PM »
hey, i just got the Yoshimura RS-3 Full exhaust system, Its friggin awesome- except for 2 things.....

1) Rear blinkers wont fit back on (replaced with small LED's Instead- No prob, undertail is coming soon...)

And The Big Problem...

2) The bracket holding the exhaust is an inch shorter than the stock one and doesnt have a footpeg......

Is there a new bracket out there?
Should i get one machined?
Or am i fucked?

Thanking everyone in advance,
Mike

Logged
"The only thing better than going fast.....is going faster."
2004 GSXR1300 LTD
Top Speed 150 mph on the GSP circa Exit 60
Mods: Reflector and Warning Sticker Removal
Rear Blinker LED Mod
Yoshimura Complete RS-3 Racing System

Offline Busa Quick

  • Post Master
  • *****
  • Posts: 1226
Yosh RS-3,NEED HELP! Forced me to remove passenger footpegs!
« Reply #1 on: August 14, 2004, 08:48:39 PM »
I guess you must have bought the High Mount? Mine is the standard mount and I didn't have any problems.

Mark
Logged
Black and Purple 04, MY MODS: Turbo, .08 spacer, s2000 injectors, yosh cams 7.2 spring, heavy clutch springs, APE valve springs, raised rev limiter to 11,500 rpm with ignition cut only, using only stock ECM with Petrik reprogramming method,

Offline 02SE

  • Post Apocalyptic Whore
  • ********
  • Posts: 11649
Yosh RS-3,NEED HELP! Forced me to remove passenger footpegs!
« Reply #2 on: August 14, 2004, 10:29:52 PM »
You can buy the low-mount mid-pipe from Yoshimura, which uses the stock footpegs.
Logged

Offline NewJerseyBusa

  • Post Whore
  • ****
  • Posts: 567
Yosh RS-3,NEED HELP! Forced me to remove passenger footpegs!
« Reply #3 on: August 16, 2004, 02:33:16 PM »
I will trade you my low mount mid pipe for your hight mount mid pipe?  Thats why you dont have room for the rear footpeg?  i will pm you
Logged
1397 JE Pistons
Pair valve Mod
Full AirBox Mod
Ivans TRE
Speedo Healer
Acumens Digi Gear
Dyno Mapped
200 RWHP
power to the ground

Offline ICEMAN - Mayhem

  • Post Whore
  • ****
  • Posts: 612
Yosh RS-3,NEED HELP! Forced me to remove passenger footpegs!
« Reply #4 on: August 19, 2004, 05:07:00 PM »
You bought the High Mount Pipes. See if you can get a mid pipe for the standard RS-3 setup. Thats what I have and it uses the footpeg
Logged
Pages: [1]   Go Up
« previous next »