Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: 1/4" JIC....-4an fitting  (Read 4877 times)

Offline 02 busa se

  • Post Whore
  • ****
  • Posts: 844
1/4" JIC....-4an fitting
« on: April 20, 2005, 01:26:45 PM »
I need a Y block..-4an.. I found a 1/4" flare tee ( JIC) that screws right on the Nos line and tightens up....does anyone know if this will work..2.00 compared to $20.
Logged

Offline SJJBusa

  • Mad Post Whore
  • ******
  • Posts: 2399
1/4" JIC....-4an fitting
« Reply #1 on: April 20, 2005, 01:45:17 PM »
Most flare fittings are 45 degree taper, and all AN fittings are 37 degree taper.
Logged

Anonymous

  • Guest
1/4" JIC....-4an fitting
« Reply #2 on: April 20, 2005, 01:56:38 PM »
this is a brass flare fitting called a "37" must mean degree of flare.
Logged

Offline 02 busa se

  • Post Whore
  • ****
  • Posts: 844
1/4" JIC....-4an fitting
« Reply #3 on: April 20, 2005, 02:07:04 PM »
sorry..forgot to log in..so this will work...
Logged

Offline A&J Performance

  • Post Master
  • *****
  • Posts: 1884
    • http://www.A-JPerformance.com
Re: 1/4" JIC....-4an fitting
« Reply #4 on: April 20, 2005, 05:40:52 PM »
Quote from: 02 busa se
I need a Y block..-4an.. I found a 1/4" flare tee ( JIC) that screws right on the Nos line and tightens up....does anyone know if this will work..2.00 compared to $20.


If your solution does not work ,let me know.
Ill get you what you need.
 :wink:
Logged

Anonymous

  • Guest
1/4" JIC....-4an fitting
« Reply #5 on: April 20, 2005, 08:00:18 PM »
yes JIC and An are same.
Logged
Pages: [1]   Go Up
« previous next »