Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Need help mounting  (Read 2577 times)

Offline busa107

  • Post Whore
  • ****
  • Posts: 507
Need help mounting
« on: July 25, 2005, 03:27:44 PM »
I need some help mounting my nozzles in the ram air tubes. Are you guys just drilling the hole a little smaller than the nozzle a thread it in. Or should I be trying something else??? I am installing a dual nozzle setup with a AJ controller. I just dont want the nozzle coming lose or turning the wrong direction from the vibraton.  :?:
Logged

Offline chevelle

  • Post Whore
  • ****
  • Posts: 940
  • Gender: Male
Need help mounting
« Reply #1 on: July 25, 2005, 03:52:10 PM »
thats what i did (drilled the holes on the small side) threaded them in,and put a little silicone on them (external) to hold it in place
Logged

Offline Rice Ya

  • Legacy Rider
  • Universal Post Whore
  • *
  • Posts: 5714
Need help mounting
« Reply #2 on: July 25, 2005, 08:00:57 PM »
Put em in the bottom of the air box.
Logged
Untill you give it everything you've got, you won't know if you got what it takes. Dave Schultz

Offline E-RACER

  • Universal Post Whore
  • *******
  • Posts: 9408
Need help mounting
« Reply #3 on: July 26, 2005, 04:58:08 PM »
I have them in the ram air tube part of the Box,there tapered and yes a smaller hole and thread them in but dont over tighten them..
Logged
Pages: [1]   Go Up
« previous next »