Ok welded my clutch cam up, we will see how it does. So far seems good, was not as hard as I thought it would be.
I took it apart looked at it and came up with this.
Ok what I did was bolted the center peice back up and torqed to specs to make sure it was lined up right. Make sure the dots on the cam and the hub are togther, book says to do that, not sure if it matters after welding but I did.
Once I bolted it up I put this L bracket on and pulled the assembly up, then I took a screw driver and centerd the tabs in the groves. Once I did this I was able to tighten the bolts up a little more. I used the screw driver and worked everthing till it would no longer move tighting the 2 bolts on the L bracket as I worked. Once I did this the assembly was very solid. I then put a small tack on each of the 3 tabs, this kept everything from moveing. Put the whole clutch back together and tested it, everything looked good so I took it back apart, took the hub out of the bike and weilded it up. Sorry I was a little nerveous and didnt take any other pics. You should be able to figure out how I did it by looking at the pics. I found the key was to make sure everything seated, when I measured it after reinstalling there was less then .004 of a inch from one side to the other difference.
I figure it should be fine
I hope, we will see as the season progresses hehe.