Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: line length  (Read 2182 times)

Offline black1216

  • Apprentice Post Whore
  • **
  • Posts: 11
    • http://www.headporting.net/
line length
« on: April 24, 2006, 03:12:53 PM »
 need a liittlle info on proper lines length from solenoid to nozzle .. setup sheet just said to keep them as short as possible. but didnt say what was to long .. my  lines ended up about 18 inches is this to long ?

 wet install on oldschool bandit ..  thanks for any advice .
Logged

Offline E-RACER

  • Universal Post Whore
  • *******
  • Posts: 9408
Re: line length
« Reply #1 on: April 26, 2006, 11:42:31 PM »
Poly lines or braided??

If Poly you could make them as long/short as you like..the closer the solenoid is to the nozze the faster the feel..if braided your pretty much stuck with the lenght they gave ya..

On a wet kit it doesnt really matter too much IMO..
Logged

Offline turbo1320

  • Rider
  • ***
  • Posts: 169
  • Gender: Male
    • www.1320straightliners.com
Re: line length
« Reply #2 on: May 14, 2006, 12:52:00 PM »
You want the Nozzle on the solenoid and the hose from bottle you want a -3 line not a -4 its to big. A -3 line 48in long can flow enough NOS to support 388HP.If hit is to hard put a progressive controler on it. We have ran 8.66 on a 35 shot set up like this on stock GSXR1000 at 166MPH  with just a bolt on Muffler foot shifting.
Logged
Pages: [1]   Go Up
« previous next »