Got one, cut black/white ground per Dennis' earlier post. Bike runs, doesn't seem to miss a beat through the rev range.
Here's problem.
I've got a Dyna shift minder and light. It is hooked up to coil sticks using 4 wire harness from Schnitz. Worked fine for 2 years, worked fine untill the ignition module was installed. Now occasionally the shif light will go off whenever it wants to. It just flickers, but I lost the cap so at night it is blinding. This was discovered last night after hooking up the igniton module.
I'm planning on rechecking wire connections, but they were fine yesterday and they are soldered not scotch locked.
Suggestions above that would be helpful
