Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Chain/Sprocket Offset?  (Read 2399 times)

Offline NewJerseyBusa

  • Post Whore
  • ****
  • Posts: 567
Chain/Sprocket Offset?
« on: August 16, 2006, 09:23:44 AM »
I have a 210 XXL Metezler on my bike and have to offset the chain and sprocket, has anyone done this and how much difference is it from the stock 190 setup?
Logged
1397 JE Pistons
Pair valve Mod
Full AirBox Mod
Ivans TRE
Speedo Healer
Acumens Digi Gear
Dyno Mapped
200 RWHP
power to the ground

Offline ny05busa

  • Post Whore
  • ****
  • Posts: 764
Re: Chain/Sprocket Offset?
« Reply #1 on: August 18, 2006, 04:08:03 PM »
I am just guessing here but a 200 will mount rite on and a 210 is 10mm wider. I would think if you moved the wheel over that much it would be fine.Dont forget to move the sprocket out as much as you move the wheel over. This sound about rite to everyone?
Logged
Bought 04/21/05 silver n blue busa. TI force, 16/42 , chrome lowereing clamp, lowering links, speedoheeler, double bubble, bar ends, fairing screens, tobin seats with pad, GANN arm, chrome carrezzios, carpenter 1397,vortec rearsets, mps nos, air shifter

Offline NewJerseyBusa

  • Post Whore
  • ****
  • Posts: 567
Re: Chain/Sprocket Offset?
« Reply #2 on: August 18, 2006, 07:57:40 PM »
ok where can i get spacers for friont sprocket shaft, sprocket cover,and rear sprocket studs?   Thanks
Logged
1397 JE Pistons
Pair valve Mod
Full AirBox Mod
Ivans TRE
Speedo Healer
Acumens Digi Gear
Dyno Mapped
200 RWHP
power to the ground
Pages: [1]   Go Up
« previous next »