Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: single nozzle line routing  (Read 2181 times)

Offline chevelle

  • Post Whore
  • ****
  • Posts: 940
  • Gender: Male
single nozzle line routing
« on: November 14, 2006, 06:47:45 AM »
thinking about trying a single nozzle,i have everything to do the swap,lthe shortest route would be between the throttle bodies,it looks like there is plenty of room,the throttle shaft is a bit of a concern,routing the line this way would allow me to use a 2 ft. #3 line
Logged

Offline Gixx1300R

  • Mad Post Whore
  • ******
  • Posts: 2042
Re: single nozzle line routing
« Reply #1 on: November 15, 2006, 03:54:24 PM »
If you run the line between the throttle bodies make sure you zip tie the line out of the way so the shaft on the throttle bodies will not get caught on it. It would suck to have a throttle stick at WOT.
Logged
War is nothing more than Old Men talking while Young men die

Offline chevelle

  • Post Whore
  • ****
  • Posts: 940
  • Gender: Male
Re: single nozzle line routing
« Reply #2 on: November 15, 2006, 06:37:58 PM »
yes,that would suck,i think i can keep it safely out of the way

i have a few more things to try with the dual nozzle setup before i give it a try
Logged
Pages: [1]   Go Up
« previous next »