SuzukiHayabusa.org

GENERAL => BIKE TALK => Topic started by: po boy on January 30, 2021, 07:20:14 AM

Title: What pins do I jump in the connector in the tail to read FI fault codes
Post by: po boy on January 30, 2021, 07:20:14 AM

05 Busa. FI light is on.Been so long since I did it, I can't remember the way to use a paper clip to take the place of Suzuki's 'special tool' on the connector in the tail.

Title: Re: What pins do I jump in the connector in the tail to read FI fault codes
Post by: RansomT on January 30, 2021, 08:56:12 AM

In the 4 pin molex, there are only 2 wires connected.  Just bridge those.

Title: Re: What pins do I jump in the connector in the tail to read FI fault codes
Post by: po boy on January 30, 2021, 09:15:34 AM

Thank you. As soon as I read that I remembered there's only 2 wires. Been 15 years since I looked at one, lol.

Title: Re: What pins do I jump in the connector in the tail to read FI fault codes
Post by: TT on February 11, 2021, 12:20:29 PM

install a permanent  micro toggle switch & hide / mount it in the tail somewhere so all you need to did is flip the switch to get codes