Dragzooks,
I dont have a digital camera.
However this is very easy to do your self , If your building engines you can do this easily.
Just take a drill bit the size of the gallery that feeds the #1 main. Lay your lower case on something so you can drill straight thru. drill thru from the top to the bottom. turn the case over and drill a larger hole 1/2 way up , what I used was a 1/4 in 90DEG fitting like on a NOS feed line, I used all stainless braided line and anodized fittings so it looked professionally done instead of a JERRY RIG. I had a line made the was just long enough to reach so it was neat and tidy.
the main gallery has a clean out on the right side of the engine just above the oil sending unit , That is where I fed the line from.
Its easy after you look at it.
BTW I left out odvious things like TAPPING the hole and TEFLON tape