Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Measurment of holes the on 3 hole dogbones.  (Read 2243 times)

Offline busa tamer

  • Rider
  • ***
  • Posts: 201
  • Gender: Male
Measurment of holes the on 3 hole dogbones.
« on: February 15, 2011, 04:38:20 PM »
  I'm installing a set of Soupy's adjustable lowering links,and I need to know how long center to center for all 3 holes.
 I lowered the front 1 1/8 in.The second hole is close to what I want.Does anyone know how low the second and third holes actually lower the rear? I've used the second hole on other Busas I've owned.I want to set the length before I install the adjustiabe links. Thanks.  Harold .
Logged

Offline E-RACER

  • Universal Post Whore
  • *******
  • Posts: 9408
Re: Measurment of holes the on 3 hole dogbones.
« Reply #1 on: February 15, 2011, 04:55:52 PM »
Just make them about a half inch longer than your stock ones and go from there..make sure there both even to start with./.

soupys are easy to adjust once on the bike..I have them on My 1000's//
Logged

Offline Scott123007

  • Post Whore
  • ****
  • Posts: 599
  • Gender: Male
Re: Measurment of holes the on 3 hole dogbones.
« Reply #2 on: February 15, 2011, 07:41:54 PM »
It is critical that those links are set to the EXACT same length, or all the load will only be on one.
Logged

Offline busa tamer

  • Rider
  • ***
  • Posts: 201
  • Gender: Male
Re: Measurment of holes the on 3 hole dogbones.
« Reply #3 on: February 17, 2011, 10:47:12 AM »
   

Thanks for the help.I measured the second hole  on a three hole dog bone it was 5 1/2 in.
 Soupys came set the same.Just the right height for me .  Harold.  (the old man)
Logged
Pages: [1]   Go Up
« previous next »