Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: help please relay not working  (Read 3712 times)

Offline dave393

  • Rider
  • ***
  • Posts: 316
  • Gender: Male
  • southcentral MN
help please relay not working
« on: July 28, 2012, 12:35:13 PM »
here is my problem, power to pin 85, ground trigger from nos controller on 86,  30 and 87A will should disconnect when relay is triggered by nos controller. problem is it is not clicking and not doing what i think it should. any help will be appreciated.
Dave
Logged
Interstate Junction Motorcycles ,Minnesota .
 Ward Performance Head and cams 445/415

New Best 1/8 mile  4.90 et  152 mph , 7.54, 184.77

Offline sportbikeryder

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 7352
  • Gender: Male
Re: help please relay not working
« Reply #1 on: July 28, 2012, 02:15:26 PM »
Is the nitrous controller grounding as it should?

Connect a temporary ground jumper and see if it energizes teh coil. If it does, it's teh nitrous controller. If it doesn;t, it's either the relay itself or a power source issue.
Logged
Any day on a motorcycle like this that ends just needing parts and labor is a good day.
4.82, 158.67mph 1/8th mile 7.350, 200.32mph 1/4 mile Riding

4.392, 176.79mph 1/8th mile  6.610, 228.15mph 1/4 mile Tuning

Offline dave393

  • Rider
  • ***
  • Posts: 316
  • Gender: Male
  • southcentral MN
Re: help please relay not working
« Reply #2 on: July 30, 2012, 07:11:45 PM »
Thanks for the reply Sportbikeryder. It was 2 different bad relays (same brand). Got a bosch and all works as normal.
Logged
Interstate Junction Motorcycles ,Minnesota .
 Ward Performance Head and cams 445/415

New Best 1/8 mile  4.90 et  152 mph , 7.54, 184.77
Pages: [1]   Go Up
« previous next »