Haybusa Parts and Service Member Support

Author Topic: 06 busa crank but no start.  (Read 5267 times)

Offline senior_lp

  • Apprentice Post Whore
  • **
  • Posts: 19
  • Gender: Male
  • Homemade Mechanic
06 busa crank but no start.
« on: June 25, 2013, 10:21:32 AM »
I have an 2006 Busa that once started and ran fine but now just turns over. I know it's getting fuel but I think not all my plugs are firing. Plugs are new and so is the battery. I did leave it outside with no seat on and then it rained big time. Every since then, nothing. I have eliminated all the switches and relays as bad. Turns over strong but that's it.fuel pump primes. Any ideas. My guess is ecu, I do get an f1 after holding the start to long.

Offline sportbikeryder

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 7352
  • Gender: Male
Re: 06 busa crank but no start.
« Reply #1 on: June 25, 2013, 11:10:14 AM »
Did you check the code?

My guess is something with the cam sensor.
Any day on a motorcycle like this that ends just needing parts and labor is a good day.
4.82, 158.67mph 1/8th mile 7.350, 200.32mph 1/4 mile Riding

4.392, 176.79mph 1/8th mile  6.610, 228.15mph 1/4 mile Tuning

Offline senior_lp

  • Apprentice Post Whore
  • **
  • Posts: 19
  • Gender: Male
  • Homemade Mechanic
Re: 06 busa crank but no start.
« Reply #2 on: June 25, 2013, 11:49:32 AM »
I've always assumed the f1 went to the ecu. Don't know how to check can sensor but People did say they thought my timing was off. Didn't even start with my tre disconnected.

Offline moparict

  • Post Whore
  • ****
  • Posts: 737
Re: 06 busa crank but no start.
« Reply #3 on: June 25, 2013, 11:52:13 AM »
There is a plug on the rear, left side of the bike (as you set on it).  If you jump the two wires, it will tell you the codes where you are reading the "F1" code now on your dash.  You can download the manual somewhere.  Do a search, I'm sure you'll find it.

Offline knecum

  • Mad Post Whore
  • ******
  • Posts: 2092
  • Gender: Male
  • The Recipe!
    • www.knecumpower.com
Re: 06 busa crank but no start.
« Reply #4 on: June 25, 2013, 02:02:00 PM »
F1 is formula one, Fi is fuel injection!! :wink:

Offline moparict

  • Post Whore
  • ****
  • Posts: 737
Re: 06 busa crank but no start.
« Reply #5 on: June 25, 2013, 02:06:41 PM »
F1 is formula one, Fi is fuel injection!! :wink:

You laugh, but I had a fella mad as he11 with me because he couldn't find the "F1" fault code.

Offline senior_lp

  • Apprentice Post Whore
  • **
  • Posts: 19
  • Gender: Male
  • Homemade Mechanic
Re: 06 busa crank but no start.
« Reply #6 on: June 26, 2013, 06:42:50 AM »
Can I pull the cam sensor and give it a cleaning if need be? Or if it's bad, it's bad. I haven't gotten the chance to pull the fi codes, I'm just jumping ahead to just ensure I have all the info needed.

Offline senior_lp

  • Apprentice Post Whore
  • **
  • Posts: 19
  • Gender: Male
  • Homemade Mechanic
Re: 06 busa crank but no start.
« Reply #7 on: June 28, 2013, 11:12:54 PM »
So I jumped the connector and the code received was c00. Any other ideas?