TECHNICAL > MODS
Gen 1, base gasket? Yoshi cam timing? nitrous
08BusaD500:
I have a 03 stock motor, street riden and drag raced. Recently got yoshi stage1 cams, head studs, and 47lb valve springs. I was planning on spraying a dry 50 shot through the ecu. Curious if it's safe to remove the base gasket and run a .030 head gasket? Is this a common thing to do or will I run into clearance problems? Does it help much bumping up the compression this way or not really? Also looking for ideal cam timing numbers for the yoshi's. I've read 104,106 is a good place. Would timing the cams differently effect the nitrous much? Thanks
firemanjim:
IIRC stock head gasket is 30 and thinner Cometic is 18, should have plenty of clearance. Think stock intake is 106 so 104 is a bit low.
08BusaD500:
What would you recommend for cam timing?
Stainless1:
Did you get a Cam Card with your cams? The cam card will tell you their recommended setting for the cam
Stainless1:
This might help
http://www.suzukihayabusa.org/forum/index.php?topic=73617.0
Navigation
[0] Message Index
[#] Next page
Go to full version