TECHNICAL > HELP!
99 gen 1 fuel pump and pressure regulator replacement?? now has second Issue?
BillyBoyBusa:
So What can i do to replace my 99 gen 1 fuel pump and pressure reg/
that is not avaible, or is it?
I could only imagine plenty of you have had to do so.
I have ordered in a quantum pump and reg that don't match up.
Any suggestions on the correct route to resolve my need ??
a conversion?
Thanks.
BillyBoyBusa
BillyBoyBusa:
--- Quote from: BillyBoyBusa on November 15, 2020, 01:32:12 PM --- So What can i do to replace my 99 gen 1 fuel pump and pressure reg/
that is not avaible, or is it?
I could only imagine plenty of you have had to do so.
I have ordered in a quantum pump and reg that don't match up.
Any suggestions on the correct route to resolve my need ??
Thanks.
BillyBoyBusa
--- End quote ---
Nosgsx1300:
When I needed a pump for my 2000
Accel 74701 pump
Mallory regulator 29389
regulator has risen in price by about $50 since I did mine 8 years ago
Pump fed me till 300 Hp
BillyBoyBusa:
I was able to get fuel problem going , when it was last replaced the pump wire was pinched in the stock external pump housing cover,
With that resolved and after riding a few times. A new issue has come up, while either hard acceleration after letting off the throttle or hard deceleration with no throttle, the motor shuts off, it starts back up with no issue, it even starts back while rolling.
I have installed a T I P BYPASS , to Eliminate Possibly a bad T I P sensor, because that’s how this problem was acting.
Boys i need some advice I am sure someone has had the issue ???
BillyBoyBusa:
Thanks to NOSGSX 1300 for responding
Navigation
[0] Message Index
[#] Next page
Go to full version