TECHNICAL > HELP!
Clutch issue
firemanjim:
Hayabusa folks, 2005 Gen 1 clutch, I have a billet basket all the rest is stock Gen 1 stuff. For some reason if I used the stock length pushrod on the slave side it held the clutch open. I had 4 stock pushrods all the same and one about 1/4 inch shorter. Tried different slave, different sprocket cover, replaced the center clutch pushrod, but the clutch only worked with the short pushrod--- and don't ask me where it came from!! Anyone else had this??
sportbikeryder:
Perhaps an issue with the clutch master or reservoir?
It isn't over filled with fluid is it?
John
firemanjim:
Swapped all of that as well off another Busa.
RansomT:
How's the stack height on the clutch?
RansomT:
IIRC, The OEM clutch rod is 132.5 mm in length.
Navigation
[0] Message Index
[#] Next page
Go to full version