Haybusa Parts and Service Member Support

Author Topic: Question on front n rear sprocket  (Read 1316 times)

Offline Busanostra

  • Rider
  • ***
  • Posts: 162
  • Where am I?
Question on front n rear sprocket
« on: August 16, 2022, 03:14:25 PM »
I'm putting a busa engine on my RZR8 (sort of dirt vehicle)
What is the smallest front and the biggest rear sprocket available to fit in hayabusa?
I need to use a short gearing not tall gearing.

Thank you folks

Offline Red

  • Post Master
  • *****
  • Posts: 1355
  • Gender: Male
    • http://www.revival.tv
Re: Question on front n rear sprocket
« Reply #1 on: August 16, 2022, 04:25:28 PM »
Gen1 , 2 or 3 ?
1999 Prostar West Super Gas Champion !
2000 NMRA / Prostar Pro E/T runner up.
2001, 2002, & 2003 NMRA Pro E/T Champion !
2004 #3, 2005, & 2006 NMRA Pro E/T runner up.
2007 Pro. St. Legal #6, NMRA Pro E/T Champion !
2008 MDRA Super Streetbike Champion !

Offline Busanostra

  • Rider
  • ***
  • Posts: 162
  • Where am I?
Re: Question on front n rear sprocket
« Reply #2 on: August 16, 2022, 08:02:33 PM »
Oh sorry, I forgot to indicate it's GEN 1

Offline Red

  • Post Master
  • *****
  • Posts: 1355
  • Gender: Male
    • http://www.revival.tv
Re: Question on front n rear sprocket
« Reply #3 on: August 17, 2022, 04:22:38 AM »
 https://www.labusas.org/threads/chain-and-sprockets-whos-got-a-set.100571/
 
 Gen 1 has a small output shaft .   
   
 - You might find a little 15 ?
   
 Tire or rotor limits rear ! 
 
 Stock was 17 / 40 .   
   
 Red ,  *<(;{)-

 
1999 Prostar West Super Gas Champion !
2000 NMRA / Prostar Pro E/T runner up.
2001, 2002, & 2003 NMRA Pro E/T Champion !
2004 #3, 2005, & 2006 NMRA Pro E/T runner up.
2007 Pro. St. Legal #6, NMRA Pro E/T Champion !
2008 MDRA Super Streetbike Champion !

Offline Busanostra

  • Rider
  • ***
  • Posts: 162
  • Where am I?
Re: Question on front n rear sprocket
« Reply #4 on: August 17, 2022, 12:58:09 PM »
- You might find a little 15 ?


Sprocket center has 13T (front)   ---  is that possible to put in hayabusa? (so I can chop the top end)