Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: gauge installation  (Read 3618 times)

Offline 04busaLMTD

  • Rider
  • ***
  • Posts: 167
  • Gender: Male
  • ...pretty much...
gauge installation
« on: October 06, 2004, 09:46:40 PM »
have a few 2 1/16" gauges i'm looking to install on my busa...but have a question about the air/fuel one.....don't believe the bike is equipped with an o2 sensor since i have equipped with a full D&D 4:2 system....need an o2 sensor hookup in order to install this gauge...any idea if there is an o2 sensor on these bikes or if there is a way i can install this gauge and avoid having to have an o2 sensor?      

can anyone help?  know anything about it?  or is it a dead end situation?
Logged

Offline 1320jon

  • Rider
  • ***
  • Posts: 306
gauge installation
« Reply #1 on: October 06, 2004, 10:53:58 PM »
You could ship your header to me and I could put a o2 sensor bung in it ....

or you could take it to any decent muffler shop...they should have o2 sensors bungs for 5 to 8 $ and weld it in for for the same.

Just mark the pipe were you want it.
Logged

Offline the shredder#3

  • Rider
  • ***
  • Posts: 276
re 02 sensor
« Reply #2 on: October 10, 2004, 09:28:04 PM »
:D HEY BUD IM USING A SINGLE WIRE 02 SENSOR JUST GOT THE EXHAUST SHOP TO WELD IT IN. IT RUNS A AUTOMETER AIR/FUEL GAUGE.
http://
Logged
HOME OF AUSTRALIAS FIRST GHETTO KIT.

Offline sambusa

  • Post Whore
  • ****
  • Posts: 642
gauge installation
« Reply #3 on: October 24, 2004, 09:19:52 PM »
What is best place to install oxygene sensor on yosh 4in1 exshaut syst.
Logged
Pages: [1]   Go Up
« previous next »